The EM100 is Tibbo's original 10BaseT
serial-to-Ethernet product for onboard installation — it
all started with this orange module.
The EM100 has magnetics on-board and requires only
one external component — an RJ45 Ethernet connector.
This device has the lowest power consumption of all
Ethernet modules offered by Tibbo.
The EM100 is fully sealed (potted) for maximum
enviromental protection.
Specifications:
10BaseT Ethernet port with built-in
magnetics.
TTL serial port (TX, RX, RTS, CTS,
DTR, and DSR lines).
Two additional I/O lines.
Four control lines for status LEDs.
Power: 40mA @ 5V.
Dimensions: 46x28x13mm.
Fully sealed (potted) design.
Firmware is upgradeable through the
serial port or network.
